Author | Message |
jguy
Posts: 79
Location: United States Conyers, Georgia Occupation: computer programmer Age: 68 |
#95 2009-08-21 19:44 |
I'm looking to put a 90 degree bend in a 18" to 20" wide piece of 16 - 18 ga sheet metal. I've read a little bit online about using angle iron and 2x4's. Does anyone have experience doing this without a sheet metal break?
Someone at the last meeting said that George Dixon's book had something on this, but I have not found it. Thanks in advance! Jim |
|
Jim Guy
|